Our product EnerSpan Insulation with hotspots that have more information

EnerSpan is a moulded graphite polystyrene (GPS) rigid foam insulation that gives maximum efficiency, cost-effectiveness and sustainability to your insulation projects. EnerSpan is manufactured using Neopor® provided by BASF, a graphite-enhanced raw material that reduces radiation heat transfer resulting in higher thermal resistance (R-value) compared to standard CAN ULC S701.1, Type 1 EPS insulation.

With an R-value of 4.7 per inch, EnerSpan helps you achieve your desired R-value with a thinner board. EnerSpan insulation is easy to work with and install, and consistently delivers the highest true R-value performance over time. This high-performing insulation is breathable, while the closed-cell structure does not support the growth of mold, while adapting to all climate zones.

Available in 2x8 ft. and 4x8 ft., 2 ft. high bundles

Thicknesses of ¾, 1, 1 ½, 2, 2 ½ , 3, 3 ½ , 4 inches, Plus special order sizes and thickness to meet job

Easy to cut and install
Meets all building code requirements
Closed cell insulation
No Thermal Drift
Compressive Resistance of 10 psi
A True R-value of 4.7 per inch
Resistant to moisture
Uses up to 30% less material than other rigid foam insulation to achieve the same R-value, saving on building materials and installation labor
Thinner boards are needed to reach the desired R-value than others so the same effect is achieved with less material

Material Properties of EnerSpan^® Insulation

Material Property	Units	CAN/ULC-S701 Type
Material Property	Units	1	2	3
Thermal Resistance Minimum RSI per 25mm (inch) ASTM C518	m² • ⁰C/W (ft²•h•⁰F/BTU)	0.82 (4.7)	0.82 (4.7)	0.82 (4.7)
Compressive Resistance Minimum @ 10% Deformation ASTM D1621	kPa (psi)	70 (10)	110 (16)	170 (25)
Flexural Strength Minimum ASTM C203	kPa (psi)	170 (25)	240 (35)	300 (44)
Water Vapour Permeance Maximum ASTM E96	ng/(Pa.s.m²) (Perms)	300 (5.2)	200 (3.5)	130 (2.25)
Water Absorption Maximum ASTM D2842	% By Volume	6.0	4.0	2.0
Dimensional Stability Maximum, 7 Days @ 70± 2℃ (158±40F) ASTM D2126	% Linear Change	1.5	1.5	1.5
Limiting Oxygen Index Minimum ASTM D2863	%	24	24	24
Surface Burning Characteristics Classification or Rating CAN/ULC S102.2	Flame Spread Smoke Developed	220 over 500